Samsung Firmware Fix Generator V1 1 Clp365.rar -- DOWNLOAD (Mirror #1). Fix firmware reset CLP-360 CLP-365 CLP-368 CLP. To create fix firmware reset for printers Samsung. How simple it is to install fix firmware reset sent. Appeared firmware Samsung ML-1660/1665. My firmware was V1.02.0034 and now it is v1.02.0034f. Samsung Firmware Fix Generator V1 1 Clp365.rar -> DOWNLOAD (Mirror #1).

Start by removing the cartridges by pulling the handle on the left and right side of the cartridge. Then, remove the box marked with 'YMCK' by pulling it towards to you. Then, there's a handle on the bottom of the printer (with a barcode sticker). Pull it and wiggle it towards to you until it pops out ( DO NOT LIFT UP! Only pull forward!!) Now set the cartridges and photo drum somewhere safe and cat/dog/kid-free. It is ideal to turn down the light level a bit so the photosensitive coating is not degrading. Toner might be harmful if ingested or inhaled.

Photosensitive coating contains heavy metal. Do not let your children or your pets play with it. If you happened to spill some of the toner, use damp cloth to wipe it off. Do not use hot water.

If your clothings are stained by the toner, use cold water and sticky tape to get rid of toner stain. NEVER USE HOT WATER. Do not tumble dry. Grab your smartphone or a trusty torch (FLASHLIGHT. Not gas torch!

If you use open flame inside the printer, it might damage it or cause explosion.) Look into the glossy black plastic film inside the printer, just above the spot where the green cylinder was sitting on. If it's dirty, take a DRY lint-free cloth (like a glasses towel) and wipe it softly until there's no leftover toner or dust left on the film. DO NOT TOUCH THE SURFACE WITH YOUR FINGERS OR PRESS IT DOWN.

It WILL damage the surface of the film and WILL cause irreversible loss of printing quality. If it's not dirty, look at the green cylinder you just pulled out on the previous step. DO NOT SHINE BRIGHT LIGHT ONTO IT. It will shorten the lifespan of the photosensitive imaging drum. If it's dirty, press on the sheared gear (white plastic) on the right side of the drum, careful not to touch the surface of the drum, and wipe the drum with lint-free cloth. Repeat the process to all sides after turning the gear towards to you.

There's a reason for this step. Because of the way this printer is designed, you cannot turn the transfer film manually. You have to wipe off all sides of the film, so you have to somehow make it spin.

Here's how: 1. Insert the photo drum back into the original position. Download free full game pc version. Insert the YMCK box back into the place. DO NOT INSERT TONER CARTRIDGES YET. Close the front door and let the printer initialize for few seconds. Just after the sound stops, open the door. Remove two things you inserted earlier.

Wipe the photo drum and/or the transfer film. Repeat as necessary.