Last Updated on Sat, 09 Mar 2019 The pistols are unique in design, although inevitably they have some features in common with other. The pistol was designed by, said to have been a German by birth but who was a resident of Liege, Belgium, until about the close of World War I. The first are thought to have been made in Belgium in 191516. The pistol has an outward appearance similar to the F.N., but internally it is quite different (Fig. To disassemble, the magazine is first removed and the slide is pulled back and then allowed to move forward slowly until it comes into a position where it can easily be lifted off.

The barrel is pivoted at the rear end and can be removed by turning it at right angles, in which position it can be slid out. This pistol has but one safety and this is a which operates in an unconventional manner. When the grip safety is in the „in' position the gun can be fired by pulling the trigger, but when it is in the „out' position pulling the trigger alone, without depressing the safety, will not cause the gun to fire. To apply the safety, one must push in a little button which is located on the left side of the grip frame, below the rear end of the slide. This causes the safety to spring out, and when in this pisition it must be depressed before the trigger can be pulled.

Serial #: 2249xx Markings: Crown N Proofs, Ortgies Paten right side frame, Serial number and GERMANY in front of trigger guard, DEUTSCHE WERKE –monogram- WERK ERFURT on left side of slide. Other Information: more wear on end of barrel, Original logo’d magazine. Serial number 15665 is marked Ortgies & Co., whereas serial number 16110 is marked Deutsche Werke. After publication Maus was also made aware of serial number 15921 with Hamburg Ordnungspolizei markings and an Ortgies & Co. Slide inscription.

This safety device is certainly not one to be recommended because it is a very dangerous one. Firstly, when one pulls the slide back in the normal manner to transfer a cartridge from the magazine to the barrel chamber, the safety member is pushed in (as one grips the pistol) and it remains there unless one releases it by pushing in the release button. If one forgets this little detail he may be courting disaster.

Secondly, in some specimens seen it is very easy to push the grip safety in accidentally, as the pressure required is very small. Cases are known where this has happened and accidental discharges have occurred in consequence. Any grip safety which does not require a substantial pressure to depress it is dangerous, and obviously more so when it automatically locks itself in this position when it is depressed-as is the case with the Ortgies. Some time soon after World War I, Ortgies went to Erfurt where he organized the firm Ortgies and Co. To manufacture his pistol. Production of the 7.65 mm.

Pistol seems to have started in 1920, and because the weapons were attractive in appearance and were well made they soon attained popularity, which fact naturally attracted the notice of other manufacturers, including Deutsche Werke, A.G., of Erfurt. This firm purchased the rights, tools, designs, and unfinished parts from Ortgies and Co. But just when this purchase was made is not known. Caliber was the only one produced by Ortgies and Co., but apparently they had been tooling up for the 6.35 mm. Model, because soon after Deutsche Werke took over the business a pistol of this caliber was produced. A short time later the 9 mm. Browning Short (.380) was brought out, but this did not enjoy the popularity attained by the smaller models. Autocad 2014 torrent russkaya versiya download.

Production of the pistol in this caliber seems to have stopped somewhere around 192527. Deutsche Werke continued the manufacture of the pistol in the 6.35 and 7.65 mm.

Calibers until late in the 1920's. An Ortgies manual, thought to have been issued in 1919, describes the 7.65 mm. Model, listing it as available, and it also mentions but does not describe the 6.35 model.